November 17, 2026
Journal Article

Comparison of CO2-Derived Vitrimer and Conventional Epoxy in Carbon Fiber Composites: Mechanical, Thermo-Mechanical, and Recycling Performance

Abstract

The environmental impacts and end-of-life challenges of conventional carbon fiber-reinforced polymer (CFRP) composites have driven the development of recyclable polymer composites such as vitrimer-based composites. Repairable and recyclable vitrimer composites have been produced by leveraging their mechanical properties and topological rearrangement through bond exchange reactions. This study presents the fabrication of vitrimer carbon fiber (CF) (0°/90°) composites using a hot compression molding technique. Mechanical properties were evaluated by tensile and flexural testing, while thermo-mechanical behavior was characterized by dynamic mechanical analysis. The vitrimer/CF composites demonstrated a tensile strength of 495 MPa and a Young’s modulus of 39 GPa, comparable to epoxy/CF composites, which displayed a tensile strength of 514MPa and a Young’s modulus of 41 GPa. However, vitrimer/CF exhibited weaker flexural strength (385 MPa), and flexural modulus (42 GPa) compared to epoxy/CF (660 MPa, 47 GPa), due to matrix softening and interfacial debonding caused by bond exchange. DMA analysis showed a reduced storage modulus and an earlier onset of glass transition temperature (Tg) in the vitrimer composite systems, signifying increased molecular mobility compared to epoxy/CF composite. Scanning electron microscope (SEM) analysis demonstrated progressive matrix cracking and fiber pull-out in vitrimer composites, in contrast to the brittle failure observed in the epoxy composite. Recycled vitrimer/carbon fiber composites had a flexural strength of 256MPa and a flexural modulus of 40 GPa. The loss of strength was predominantly attributed to fiber breakage at the initial failure. The results show that vitrimer-based composites combine strong mechanical integrity with reprocessability, offering potential cost advantages in recycling and extending their suitability for high-performance CFRP applications.

Published: November 17, 2026

Citation

Kumar V., W. Kuang, J. Wang, S. Yoon, J. Eagan, and S. Joshi. 2026. Comparison of CO2-Derived Vitrimer and Conventional Epoxy in Carbon Fiber Composites: Mechanical, Thermo-Mechanical, and Recycling Performance. Journal of Materials Science 61:36735–36752. PNNL-SA-217712. doi:10.1007/s10853-026-13939-7

Research topics