SEPTEMBER 18, 2025 Journal Article Friction Surface Layer Deposition of triple-phase Al10Cr12Fe35Mn23Ni20 High Entropy Alloy: Process Optimization and Microstructural Evolution ( Read More )
SEPTEMBER 3, 2025 Journal Article Feasibility of Algal Biochar, a Byproduct of Biofuels Production, as a Supplemental Cementitious Material ( Read More )
AUGUST 30, 2025 Journal Article Hydrothermal Liquefaction of Wastewater-Grown Algae to Produce Sustainable Aviation Fuel: A Combined Experimental Study and Techno-Economic Assessment ( Read More )
AUGUST 20, 2025 Conference Paper Deconfliction of Centralized and Distributed ADMS and DERMS Applications ( Read More )
AUGUST 20, 2025 Journal Article Advancing Sustainable Aviation Fuel with High-Energy-Density Bicycloalkanes Production from Corn Stover Mixed Sugars ( Read More )
AUGUST 7, 2025 Conference Paper Additive Friction Surfacing of High-Strength Low-Alloy Steel ( Read More )
AUGUST 2, 2025 Journal Article Microstructure and Temperature Dependent Indentation Response of Additively Manufactured Precipitation-strengthened Al0.3Ti0.2Co0.7CrFeNi1.7 High Entropy Alloy ( Read More )
JULY 31, 2025 Journal Article Behavioral simulations and experimental evaluations of stress induced spatial nonuniformity of dynamic bulk modulus in additive friction stir deposited AA 6061 ( Read More )
JULY 31, 2025 Journal Article Using a Recirculating Anaerobic Dynamic Membrane Bioreactor to treat hydrothermal liquefaction aqueous by-product ( Read More )
JULY 24, 2025 Journal Article Bio-Oil Impact on Water Diffusion and Durability of Bitumen: Influence of Aging and Salinity ( Read More )
JUNE 26, 2025 Conference Paper Programming the Future: the Essential Role of System Topology Awareness in Heterogeneous Disaggregated Environments ( Read More )
MAY 21, 2025 Conference Paper Testbed Demonstration of a Microgrid Building Block Prototype ( Read More )
MAY 16, 2025 Journal Article Additive manufacturing of soft magnetic high entropy alloys: A Review ( Read More )
MAY 8, 2025 Journal Article Testing and Modeling of CLT-to-CLT Joints Made Using Hardwood Dowels and Screws with 1 Varying Spacing ( Read More )
APRIL 8, 2025 Journal Article Techno-economic analysis of bioplastic and biofuel production from a high-ash microalgae biofilm cultivated in effluent from a municipal anaerobic digester ( Read More )
APRIL 4, 2025 Report Solid State Additive Manufacturing of Oxide Dispersion Strengthened-FeCrAl Alloy Components for High-Temperature Supercritical CO2 Power Cycle Applications ( Read More )
APRIL 1, 2025 Journal Article Additive manufacturing of AISI M2 tool steel by binder jetting (BJ): Investigation of microstructural and mechanical properties ( Read More )
MARCH 6, 2025 Journal Article Characterizing and communicating uncertainty: lessons from NASA’s Carbon Monitoring System ( Read More )