Low-enriched uranium alloyed with 10 wt% molybdenum (U 10Mo) has been identified as a promising alternative to highly enriched uranium as fuel for the nation’s high-performance research reactors. Manufacturing the U 10Mo alloy consists of multiple complex thermomechanical processes, which is highly challenging for computational modeling. The integrated computational materials engineering (ICME) concept supports building a microstructure-based framework to investigate the effect of manufacturing processes on the material microstructure. In this report, an ICME model that combines homogenization, hot rolling, annealing, and cold rolling is presented as an example of implementing the ICME concept for modeling the manufacturing processes of the U 10Mo alloy. The integrated model enables information to be passed between the different model components, leading to an improved prediction and a better understanding of microstructure across multiple processes. The integrated model was also implemented to investigate the variation of chemical composition, thickness of the zirconium interlayer, grain growth, and carbide redistribution and fracture of U 10Mo during the thermomechanical processes. With the homogenization model, a molybdenum concentration map can be reconstructed from any given microstructure, and the homogenization time needed to reach a desired homogenization level can also be approximated. The microstructure-based finite-element rolling model, shows that the homogenization process reduces the nonuniformity in the thickness of the zirconium interlayers on the U 10Mo. With the output from the rolling model, a statistical analysis of second-phase hard particles was conducted to quantify the particle redistribution and interparticle spacing between carbides during the deformation. Also, new stringer identification criteria were proposed to predict the correlation between stringer volume fractions and hot-rolling reduction. A macro-finite-element method hot-rolling model showed that higher reduction passes can be achieved within the mill separation force range, and a new “aggressive” rolling schedule was proposed. The model also showed the importance of can material on the quality of rolled foils, with stronger can materials resulting in hot-rolled U 10Mo free of defects (waviness, dog-boning). The deformation-induced recrystallization model demonstrated capability to use inputs from deformation simulations of strain accumulation in U 10Mo samples to predict grain growth behavior of the fuel during thermal treatment stages. Finally, a plane-strain compression mode simulated particle fracture and calculates the void volume fraction generated during cold rolling. The macro-finite-element method cold-rolling model showed that smaller diameter rolls are necessary to achieve the desired foil thickness.